03-08-2013 12:53 AM
Dear community,
I am new to netbackup, I have a task which is to replace an old tape library to a new HP MSL 4048 tape library.
After installation, how do I edit the job settings to point to the new tape library?
Is there any guide on how to do that?
Any advice is appreciated.
Thank you.
Solved! Go to Solution.
03-08-2013 01:58 AM
I have not seen any official Symantec doc, but this subject comes up quite often in this forum.
See this post: https://www-secure.symantec.com/connect/forums/change-tape-library-netbackup-71#comment-7696441
Let us know if it helps.
03-08-2013 01:53 AM
you reconfigure the policies to use the new storage unit(s) the MSL 4048 represent. if you run the deice configuration wiazrd to the end Netbackup will create the storage unit for you.
Symantec NetBackup 7.5 Device Configuration Guide
http://www.symantec.com/docs/DOC5186
03-08-2013 01:58 AM
I have not seen any official Symantec doc, but this subject comes up quite often in this forum.
See this post: https://www-secure.symantec.com/connect/forums/change-tape-library-netbackup-71#comment-7696441
Let us know if it helps.
03-10-2013 10:44 PM
Thank you for your advice. I will update when I have the chance to try out.