07-17-2007 12:35 PM
07-17-2007 01:14 PM
07-17-2007 02:05 PM
07-17-2007 04:35 PM
Generating Reports by Using the vlteject Command
You can use the vltejectcommand with the -report option to generate reports from the command line. The following is the syntax for the command that generates all reports that have not yet been generated:
vlteject -report
You also can specify a robot, vault, profile, or session for which to generate reports.
182 NetBackup Vault System Administrator’s Guide Generating Reports
If the corresponding eject process has been completed, pending reports from the sessions selected are generated and distributed. The reports will not be generated again if vltejectis run again. If eject has not been completed, the subset of reports that do not depend on completion of eject will be generated; these reports will be generated again if vlteject-report is run again after eject has been completed.
The following is the format of the vlteject command:
vlteject -eject -report -preview [-profile profile_name] [-robot robot_name] [-vault vault_name [-sessionid id]] [-auto y|n] [-eject_delay seconds] [-legacy]
The vlteject command resides in the following directory:
UNIX: /usr/openv/netbackup/bin
Windows: install_path\NetBackup\bin
For more information about the vlteject command, see the NetBackup Commands for UNIX or NetBackup Commands for Windows manual.
▼ To generate reports by using the vlteject command
IF this works go the Netbackup Vault Admin Guide pages 182-206 to configure you vault properly.
Hope this helps.
Regards