10-12-2016 03:18 PM
Is there a way to copy collection data that I performed from one case and ingest it into a new case? I cannot seem to figure out a way to import a collection already performed. I have a few collections already done and would prefer not to do them all over again for a new case.
Solved! Go to Solution.
10-13-2016 02:37 PM
Howdy @MKimler,
This one is easy
After you have the PSTs, you'll want to stage them at your source data location and Add a case folder for the PSTs under Case Home > Processing > Source & Pre-Processing. This is the same workflow that you'd use when setting up loose files for Processing.
I hope this helps. Let me know if you need anything further.
10-13-2016 02:37 PM
Howdy @MKimler,
This one is easy
After you have the PSTs, you'll want to stage them at your source data location and Add a case folder for the PSTs under Case Home > Processing > Source & Pre-Processing. This is the same workflow that you'd use when setting up loose files for Processing.
I hope this helps. Let me know if you need anything further.
10-31-2016 07:04 AM
Hello @MKimler,
Just doing a follow up to see if you had any luck finidng the PSTs created by a Collection Task?
11-17-2016 08:44 AM
Sorry for the delay. Yes, this worked! Thanks for the information.
11-17-2016 09:53 AM
Hello @MKimler,
That's so good to hear!
This was a good question. Knowing were to find the raw PSTs created during a Collection can be a time saver when/if no review, mark up, etc. is needed and you need to get someting out the door
Would you mind marking the post as Resolved when you have a moment.