About Rajendra_Singh

Rajendra_Singh · 12-23-2020

Hi All Quick query, I have a backup with 9 streams and one parent stream. One tream was failed and parent too (ofcourse). Will this 8 streams appear in bpimagelist output? My requirement is, I want to run script to verify if all policies in list were...

Rajendra_Singh · 12-24-2020

Actually I want to confirm if my all configured policies have been backuped in a given time say last month. bpimagelist also stores successful streams in case of file system backup (even if one stream failed). I am not able to confirm if filesystem b...

Rajendra_Singh · 12-24-2020

Thanks a lot for your response. You are absolutely correct ... I also observed same ...

Rajendra_Singh · 11-15-2017

1. In case your root disk is under vxVM and you want to boot it from slice then below entries need to be removed from /etc/system file.rootdev:/pseudo/vxio@0:0set vxio:vol_rootdev_is_volume=1Below entries are to be removed if you do not want to load...

Rajendra_Singh · 11-15-2017

Run vxdisk rm disk_name for the mentioned disk twice. It should remove entries and then run vxdctl enable. It should give only one entry this time. If both entries appear again, you might need to go for device clean up or reboot ...

Rajendra_Singh · 01-19-2017

If you are running HA Setup, you can run vxresize without any problem in same way as on VxVM node without VCS. if you are using CVM, refer link below for detail. https://www.veritas.com/support/en_US/article.000028844 RgdsRajendra

VOX

User Statistics

User Activity

Need to check successful Backup Status in bpimagelist

Re: Need to check successful Backup Status in bpimagelist

Re: Need to check successful Backup Status in bpimagelist

Re: Doubts on VxVM,VCS Upgrade & root disk encapsulation

Re: vxdisk list showing disk in status

Re: filesystem resizing when vcs SG also configured