Fails at approximately the same point event ID 129 , Reset to device, \Device\RaidPort1, was issued. followed by Event ID 11 The driver detected a controller error on \Device\RaidPort1
Unfortuantly, both the original library and the new library p...
Afternoon.
I have been having massive issues with our backups since upgrading some of our Hardware. I eventually traced it down to the same issue listed here http://www.symantec.com/connect/forums/issue-dell-tl2000-tape-library with 6gbps sas hba...
Thank you
Dell have reported multiple issues, Waiting on a replacement LTO-5 Drive , then will go back to trouble shooting the rest, will update in a few days
Aaron
Results of Sundays efforts
I removed all drivers and ran a clean install, I have confirmed the 6 Gbps SAS card is compatiable with BE2014, Fired up the server, confirmed Symantec drives loaded for the Tape Drives and ran some testing
Fails at betwe...
Yes, both firmware and drivers have been installed but the issue is still occuring, As it is a production server I will not be able to take it offline till Sunday and have a good tinker then, I think I have some scsi id issues, but been unable to det...
Thank you pkh, from memory it is a non-raid card, As this post was split from another, so I will read my setup up details here.
Dell r710 running serevr 2008 R2, Back up exec 2014 sp1, fully patched
2 x Dell 6Gbps SAS HBA cards (see here )
first c...
Unfortuantly, both the original library and the new library pass the vendor diagnostics with flying colours. I'm about to set up the original library and card in a test server not running the 6Gbps SAS HBA card to confirm it is a config error with th...
