Hi,
I have a Duplicate job that follows a backup (to disk) job within my nightly backup routine.
This job fails... with the following error:
Backup set #1: "DR U_P_O Diffs"
Backup of "\\xyz\F: Raid5_part1"
Backup performed on 9/11/2007 at 10:30 PM
Storage media #1: "xyz upo disk sets"
Raid5_part1Insufficient memory available.
======================================================================
Job ended: Wednesday, September 12, 2007 at 1:25:31 AM
Job completion status: Failed
======================================================================
If I run this job in the morning, once the coffee's kicked in, it works a treat.
Dell PE 2650, 1Gb RAM, Scalar 24 SDLT tape library. BE 9.1 SP5.
The job appends to a tape, is my predicament caused by the tape drive being busy (with another job) and the duplicate job won't queue?
Has anyone else seen this problem? Any help or suggestions would be warmly received.
Steve
