12-10-2013 04:13 AM
Hello,
We are experiencing a low transfer rate while backing up windows Vm machines using backup exec agent. The job rate is 580Mb/min while it is 4000Mb/min in case of ndmp netapp protocol.
What could be the reason of the this behavior?
We are using backup exec 2010 r3 on windows server 2008 R2 64 bit.
Please help.
Tarek
12-10-2013 04:40 AM
Hi,
What are you backing up too? Tape or disk? Are you using a normal RAWS agent backup or backing up the VMs using SAN Transport Mode for instance?
Thanks!
12-10-2013 09:01 AM
Basically, we are backing up to tape LTO 5, and we have the BE remote agent installed on all virtual machine, therefore BE uses the remote agent to pull the files/files system from windows machine I dont know if we call this raws agent backup.
In addition to that, under vmware section in the backup job the SAN transport Mode is selected.
Thanks,
12-11-2013 10:44 AM
Basically, we are backing up to tape LTO 5, and we have the BE remote agent installed on all virtual machine, therefore BE uses the remote agent to pull the files/files system from windows machine I dont know if we call this raws agent backup.
In addition to that, under vmware section in the backup job the SAN transport Mode is selected.
Thanks,
12-16-2013 11:24 PM
Please can anyone help in this regard.
12-17-2013 07:30 PM
Hi Tfaraj,
Please try to read below link (Improving and troubleshooting Backup Exec performance)
http://www.symantec.com/business/support/index?page=content&id=TECH49521
This might help you solve the problem.
12-18-2013 09:57 PM
thank you Adonis.
But I noticed the the slow rate is occuring while backing up windows state, how can we solve this issue?
Regards,
Tarek Faraj
12-18-2013 10:29 PM
...I know there was an issue backing up Windows Server 2008 R2's System State. Do you have this issue if you backup any other OS's you may have?
Thanks!
12-18-2013 10:34 PM
Hi Tfaraj,
Are you talking about backup of Windows 2008 System State?
If yes, the problem "slow backup of Windows System State" is a known issue of previous version (Backup Exec 2010 R2). This issue had been resolve with the release of BE2010 R3. Please review link below
http://www.symantec.com/business/support/index?page=content&id=TECH76051
12-20-2013 01:40 AM
I already have BE 2010 R3 and the problem still persist.
Any suggestions.
Regards,