Upgrade from 10.5484 to 10d

[nicolaas_Willem]

We have it installed on a clusterd system, is there anything special we should do
like disabeling the cluster resources before upgrade ?

Will 10d uses the 10.5484 licences ?

Is there a build in driver for a sony ait 200 SCSI tape (sdx900v) or can there be a build in driver written for this tape ?

And where can i download the upgrade to 10d ?

The link in document http://support.veritas.com/docs/279332
is not working.

[tejashree_Bhate]

Hello,

You may refer to the following link

Symantec Backup Exec (tm) 10d rev. 5629 for Windows Servers Installation Files

http://support.veritas.com/docs/279332

Thanks

[nicolaas_Willem]

The machines we are installing on are in a cluster mode.

What do we have to stop from cluster resources, before we upgrade ?

[shweta_rege]

Hello,



To install Backup Exec in cluster enviorment follow the steps given below.

1, Install Backup Exec locally on all the physical nodes

2. After installation run the Cluster Configuration Wizard from Tools - Wizards

3. Select the required nodes

4. Select the shared drive in the SAN to store database and catalogs.

Note When using multiple clusters in a SAN SSO environment, it is strongly
recommended that the cluster nodes be connected to the storage devices
using a fibre switch. If you use a hub rather than a fibre switch, the hub will
receive a reset command during a failover event that causes all other components attached to the hub to be disconnected.

5. Continue with the configuration part



Thank You,

Shweta

[nicolaas_Willem]

Close but not wath i wanted to know,shweta rege:

What i wanted to now is the cluster is already up and running with an older version 10.584 on it. And resources are already created. Even for backup exec.

So wich resources from backup exec should we stop before upgrading to 10d ?

We have:

Backup Exec ip adress
Backup Exec Network Name
MSSQL$BKUPEXEC
Backup Exec Device and Media service
Backup Exec Server
Backup Exec Job Engine
Backup Exec Agent Browser
SQLAgent$BKUPEXEC

[nicolaas_Willem]

can someone help me with the above question ?