cancel
Showing results for 
Search instead for 
Did you mean: 

5230 - Set all FC ports as Initiators

lloyola
Level 1

*** Moved to new post from https://vox.veritas.com/t5/NetBackup-Appliance/5240-Set-all-FC-ports-as-Initiators/m-p/834210   ***

Hi

I have the same problem in 5230, I can't change Target(FTMS) to initiator.

dcl-nb5230.FC> Show ports
- [Info] FTMS mode: none
- [Info] Fibre Transport Deduplication state: disabled
- [Error] FC HBA card(s) are configured incorrectly and previous configuration attempt failed. Please contact NetBackup Appliance support for additional help.

**** Ports ****
Bus ID Slot Port Port WWN Status Physical State Configuration Type Speed Remote Ports
07:00.0 Slot5 1 21:00:00:24:FF:7C:10:6C Online Initiator Target(FTMS) 8 gbit/s 0x50000975f002a944
0x50000975f002a940
0x5006016309602160
0x5006016b09602160
07:00.1 Slot5 2 21:00:00:24:FF:7C:10:6D Online Initiator Initiator 8 gbit/s 0x51402ec000f5a0c6
0x500143802429469c
08:00.0 Slot6 1 21:00:00:24:FF:7C:0F:04 Online Initiator Target(FTMS) 8 gbit/s 0x50000975f002a900
0x5006016c09602160
0x5006016409602160
0x50000975f002a904
08:00.1 Slot6 2 21:00:00:24:FF:7C:0F:05 Online Initiator Initiator 8 gbit/s 0x500143802429469e
0x51402ec000f5a0c4
81:00.0 Slot4 1 21:00:00:24:FF:7C:10:60 Linkdown Initiator Initiator 8 gbit/s
81:00.1 Slot4 2 21:00:00:24:FF:7C:10:61 Online Initiator Initiator 8 gbit/s 0x5001438026e7f023
0x5001438026e7f02d
0x5001438026e7f019
0x5001438026e7f00f
82:00.0 Slot2 1 21:00:00:24:FF:7C:0F:E2 Linkdown Initiator Initiator 8 gbit/s
82:00.1 Slot2 2 21:00:00:24:FF:7C:0F:E3 Online Initiator Initiator 8 gbit/s 0x5001438026e7f02c
0x5001438026e7f00e
0x5001438026e7f018
0x5001438026e7f022
dcl-nb5230.FC>

2 REPLIES 2

Marianne
Moderator
Moderator
Partner    VIP    Accredited Certified

Please tell us about your Appliance - software version, which model (A - E), and what happened with previous config attempt: 
 FC HBA card(s) are configured incorrectly and previous configuration attempt failed.

Have you tried this?

Please contact NetBackup Appliance support for additional help.

elanmbx
Level 6

Just to follow-up - my issue was solved by appliance release 3.0.