03-01-2011 06:35 AM
Bonjour,
- server dell T610, lecteur de bande powervault LTO4-120HH
- Backup exec v12 SP5 + correctifs
Les job de sauvegarde s'executent sans probleme mais lors du changement de bande c'est le nom du support précédent qui reste affiché jusqu'au redémarrage des services.
Dans le cas d'un job avec éjection automatique en fin de sauvegarde :
- démarrage du job
- fin du job -> éjection, mais job reste dans l'état actif
- retrait complet de la cartouche du lecteur
- job passe en état planifié, plus de support affiché
- insertion autre cartouche, le support n'est pas importé
- redemarrage des services
- support reconnu
Merci d'avance pour vos idées
Solved! Go to Solution.
03-02-2011 01:15 AM
I assume that you have installed all the latest fixes to your BE. Re-install the driver of your tape drive by going to Tools --> Wizards --> Device Wizard and try your inventory job again. Doing an inventory job should not hang BE.
03-01-2011 06:11 PM
After you insert a new tape into your tape drive, you need to run an inventory job on the tape drive before it will show the label of the new tape.
03-01-2011 11:23 PM
the inventory job start but after a few moment the "state job" is "blocked communication" (communication bloquée) and nothing happens.
In the job property we have :
Etat : Serveur suspendu
After a services restart the label is showed...
03-01-2011 11:27 PM
To eliminate any hardware errors,
1) Stop all the BE services
2) test your tape drive with the manufacturer's disgnostic utility. Make sure that you select the write test.
03-02-2011 12:42 AM
1) Stop all the BE services
--> ok
2) test your tape drive with the manufacturer's disgnostic utility. Make sure that you select the write test.
---> Dell ITDT-DC R
all passed
03-02-2011 01:15 AM
I assume that you have installed all the latest fixes to your BE. Re-install the driver of your tape drive by going to Tools --> Wizards --> Device Wizard and try your inventory job again. Doing an inventory job should not hang BE.