01-25-2011 11:19 PM
Hi everyone!
Recently i'v been experiencing problems with my Backup exec 12.5 installation. Whenever a backup initiates, the windows New hardware found wizard pops up saying that it has found Generic volume shadow copy, and that it needs to be installed. The backup wont continue until I finish the wizard and install the new device windows has found. This, of course, causes the backups to time-out because i'm often not present to go through the damn wizard.
Any ideas!
01-25-2011 11:23 PM
What device you are using?
01-25-2011 11:24 PM
Hi
On which device your backup are going to too like backup to disk or tape if it is backup to disk then it is created on local disk or on NAS or using lun on SAN
Thank You
01-25-2011 11:25 PM
All backups are made to tape.
01-25-2011 11:26 PM
Hi there,
I'd start by doing a repair of BE 12.5 through Add/Remove Programs, and make sure you have all the available updates installed too.
If this worked in the past, was anything installed before this error started?
Thanks!
01-25-2011 11:29 PM
After installing SP4 and other hotfixes make sure you install the Symantec drivers for the
tape device by running tapeinst.exe
01-25-2011 11:32 PM
Hi
Can you please try this too
To rename the Catroot2 folder, follow these steps:
1. Click Start, click Run, type cmd, and then click OK.
2. At the command prompt, type the following commands, and then press ENTER after each line:
net stop cryptsvc
ren %systemroot%\System32\Catroot2 oldcatroot2
net start cryptsvc
exit
After you renamed the Catroot2 folder and restart server, please then try to run Backup program again
Please view on the link below for reference see if that helps
http://thedailyreviewer.com/server/view/generic-volume-shadow-copy-driver-problem-104473090
Thank You
01-26-2011 12:18 AM
To be honest if the creation of a shadow copy causes Windows to decide it has found new hardware then you probably need to be looking at the operating system, not the backup product.
01-26-2011 04:52 AM
Thanks for the awesome replies!
I've already done what itsmeaffinityhas suggested. I haven't restarted the server though. I'm unable to test the other suggestions at the moment. I'll get back to you when have.
01-26-2011 05:04 AM
Hi
I will wait for your update on same if that works great news but if not then as per above post you will have to call Microsoft to resolve the issue & will be out of scope of this forum
Please mark this resolved if this help you
Thank You