06-11-2014 07:17 PM
Hi all,
Did anyone manage to successfully configure the SAN multi-path to your SAN storage array through the DMP setup on the appliance 5220 v2.6.0.2?
I have an existing case with support and still waiting for backline to assist.
If anyone manages to configure this successfully, can you share with me the relevant documents for me to read up?
Our array is running on active-active mode with ALUA enabled.
However, the appliance now still only detect a primary path with no load balancing and redundacy configured.
Regards,
Li Xi
06-11-2014 09:54 PM
Which array?
06-11-2014 11:19 PM
This is for our NetApp v3140 running on OnTAP 8.1 7-Mode.
Below is the current default config seen on the appliance 5220.
ENCLR_NAME ATTR_NAME DEFAULT CURRENT
============================================================================
v31400 iopolicy MinimumQ MinimumQ
v31400 partitionsize 512 512
v31400 use_all_paths no no
v31400 recoveryoption[throttle] Nothrottle[0] Nothrottle[0]
v31400 recoveryoption[errorretry] Timebound[300] Timebound[300]
v31400 redundancy 0 0
v31400 dmp_lun_retry_timeout 0 0
v31400 failovermode implicit implicit
I have been working with support on this case for more than a week and have yet to get this addressed.
All the VMWare datastores are zoned to the appliance and mounted.
Does anyone has similar experience or documentation to share?
06-12-2014 02:08 AM
What exactly isn't working. Those settings are the defaults for AULA array. Have you tried changing them and it fails?