cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
Veritas.com
Support

Restore keeps installing drivers and rebooting

Michael_Hart-Jo
Level 2

‎02-24-2009 07:38 AM

I have tried for the last couple of days to restore to an HP ML110.  After the first boot the system did decide to sort out the HAL and then reboot, to then start the process again.  I left this to happen for 12 hours before resigning and accepting the fact that the software could even handle a small change.

 

In case you are wondering I backed up the system, which at this point ran on a single 74GB SATA HDD.  The rebuild was to the same hardware bit this time I had 2 500GB SATA HDD's in a raid 1 config.

 

I am running Server 2003 R2.  Any thoughts?

 

 

0 Kudos
1 REPLY 1

AJT
Level 6

‎02-24-2009 09:43 AM

 I would recommend restoring this image using the Restore AnyWare with Delete Existing Drivers (DED) option.  On the Restore AnyWare screen, hold the SHIFT Key when selecting Restore AnyWare.
This could be conflicts with drivers that are left in the image.  The DED option will remove more drivers.
From a thread replied to by Rich L.
0 Kudos