Thanks, I could make the device appear by moving this into the "Workgroup" which is actually our Domain. This is kinda confusing within the IOMEGA NAS setup. However, that works so far and I could use it already as a B2D Folder.
However, the next problem raised up. I created the backup jobs as usual. Target: B2D (IOMEGA-NAS). The Backup of 80GB is backing up approximately 2GB and then stops, saying "Error: Device not responding". I tried different backup set settings (20GB in size and then 1GB in size) but that didn't change the situation.
Question: Why is the backup stopping during the job after some GB were already transfferred? I checked the NAS in Explorer and could access everything, so physically all was fine.
Any ideas?
Kind Regards
Wolfgang