11-16-2011 12:58 PM
I am enabling client-side encryption on NBU 7.1. I have been unable to determine whether or not the image files being created with encryption enabled are actually encrypted.
I have enabled encryption in the policy, on the client properties and have created the keyfile.dat file.
I have also tested a restore after removing the keyfile.dat which failed. I am sure this is because the image is actually encrypted.
Does anyone know an easier way to find out if an image is encrypted other than trying to restore it?
Thanks,
Ryan
Solved! Go to Solution.
11-16-2011 01:27 PM
go to reports
Tape reports
Images on Tape
put in your media id and run the report
add the columns
Encrypted
Encryption key Tag
(if just doing kms hardware encryption - the encrypted will say no, but you will have a key tag)
11-16-2011 01:27 PM
go to reports
Tape reports
Images on Tape
put in your media id and run the report
add the columns
Encrypted
Encryption key Tag
(if just doing kms hardware encryption - the encrypted will say no, but you will have a key tag)
11-16-2011 01:43 PM
Thanks so much! I have been going nuts looking for documentation on this.
11-16-2011 02:00 PM
If the info I gave you is what you needed- I would appreciate it if you would mark my post as the solution.