11-16-2011 01:19 PM
Hi,
We do have new netbackup 7.1 infrastructure with one master & three file servers (with huge data).
We do have one new HP MSL FC tape library with 4 tape drives, which are currently zoned with netbackup master server only.
We have asked our SAN Team to zone all these 4 tape drives with 3 file servers also.
Once all these 4 tape drives will be available in 1 netbackup master server & in 3 file media servers, then how to configure them in netbackup.
We have procured netbackup SSO (Shared Storage Option) license.
Thanks
Singh
Solved! Go to Solution.
11-16-2011 04:04 PM
once all tape drives can be seen on all media servers
then you can use the gui wizard (which for some reason I have never been able to get it to work right)
as you say the tape drives are already on the master
then just open each tape drive.
click add
choose one of the new media servers
click browse
it should then show you the tape drive of the same serial number on that media server
choose it
ok
keep doing the adds until all the new media servers are listed.
then ok on out
it will ask if you want to bounce the media services on the servers.
say yes on the first one and make sure that that drive now shows all the media servers attached to it.
then do the other 3 drives and wait till the 3ed one before you do the bounce again.
then you need to create storage units for each media server and put those in the policies.
11-16-2011 02:34 PM
used to give me fits in older versions but since 6.5 it works pretty well!
11-16-2011 03:08 PM
Hi
You also need to add the SSO license on each Media Server locally to enable this - after that you can use the Wizard in the GUI which should do everything else for you and will also create the new storage units
If you need to limit the number of drives each server actually used then just reduce the number of drive in each storage unit so that rather than one server using all 4 drives it only uses two for example - it will still have access to all four so can use any two of the four in this situation
Hope this helps
11-16-2011 04:04 PM
once all tape drives can be seen on all media servers
then you can use the gui wizard (which for some reason I have never been able to get it to work right)
as you say the tape drives are already on the master
then just open each tape drive.
click add
choose one of the new media servers
click browse
it should then show you the tape drive of the same serial number on that media server
choose it
ok
keep doing the adds until all the new media servers are listed.
then ok on out
it will ask if you want to bounce the media services on the servers.
say yes on the first one and make sure that that drive now shows all the media servers attached to it.
then do the other 3 drives and wait till the 3ed one before you do the bounce again.
then you need to create storage units for each media server and put those in the policies.