06-19-2014 05:22 AM
Good Day Geeks !
Solved! Go to Solution.
07-24-2014 10:40 PM
4 weeks later and this issue is not yet resolved?
I would like to know more about what exactly was done over here:
One issue happened as we had our Netbackup\DB in X drive ,it earlier was in Y drive but we moved to X drive 6 months backup but not sure when running update everything in registry moved back to Y.
By the sounds of it, NBU installation is in a bit of a 'mess' and you will probably need assistance from Support or a trained catalog manipulation consultant to fix this.
06-19-2014 09:56 AM
I would like to know what NetBackup services are running. Could you please run a bpps and reply here. Also when you run a job, do you get any errors?
Also if you suspended scheduling, did you resume it after? nbpemreq -resume_scheduling
06-19-2014 10:01 AM
i did resume it ,all services are running and as no jobs are running so no errors
06-19-2014 10:16 AM
Follow TECH72244 to set up event manager logging. This log should show why jobs are not starting
06-19-2014 10:41 AM
also now if i stop nbpem and start it again ,it does kicks few of the jobs.
06-27-2014 06:41 AM
please bring down NBU comppletly then bring it up
07-24-2014 10:40 PM
4 weeks later and this issue is not yet resolved?
I would like to know more about what exactly was done over here:
One issue happened as we had our Netbackup\DB in X drive ,it earlier was in Y drive but we moved to X drive 6 months backup but not sure when running update everything in registry moved back to Y.
By the sounds of it, NBU installation is in a bit of a 'mess' and you will probably need assistance from Support or a trained catalog manipulation consultant to fix this.
08-05-2014 05:10 AM
ALl !
Yes ,it was issue with Netbackup DB registry path entries. Had to change them all back to the path they were prior to upgrade.